Description / ApplicationsThe Beckett GeniSysTM Display is an optional attachment for the GeniSys Primary Control that allows a technician to monitor
Page 10Screen Message Sensor/Monitor/MessageNotes/Checks### ohms avg Cad Cell Historical cycle data located in Control. Average Cad Cell resis-tance
Page 11
Form No. 61687 R04, Printed in USA 06/09CORPORATIONUSA: P.O. Box 1289 ● Elyria, OH 44036 ● Phone: 800-OIL-BURN (800-645-2876)Canada: R.W. Beckett
Page 2InstallationWith a slotted screwdriver, carefully remove the COM2 port cover on the right side of the GeniSys control. When installing the displ
Page 3The display was designed to function as both a monitor and a programmer. The display consists of two rows of 16 alphanumeric characters. Below
Page 4Standby - During this time, the burner is idle and waiting for a signal to turn on.Pre-time - The Pre-time screen will display the number of sec
Page 5Pressing the BACK (NO) key at this stage will return the display to the VIEW HISTORY screen. Pressing the PREV key will display the hours since
Page 6►NEXTCycle End Reason* * The possible cycle end reasons are as follows, Recycled - The burner was shut down bec
Page 7To return to the CYCLE HISTORY screen, press BACK (NO) once. To return to the BURNER HISTORY screen, press BACK (NO) a second time. C. Pre-time
Page 8D. Post-time Set ProgramFrom the PRE-TIME, SELECT TO CHANGE screen, press the NEXT key to access the POST-TIME (motor off delay), SELECT TO CHAN
Page 9E. Service Message ProgramFrom the POST-TIME CHANGE screen, pressing the NEXT key will display the SERVICE MESSAGE, SELECT TO CHANGE programmin
Commentaires sur ces manuels